sales@landfx.com
  +1 805-541-1003

Land F/X Community Forum

Michael Essenwein
9
Votes
Undo
Is it possible to automatically add lateral lines between heads when using the "copy along a line" or "copy along poly line" command? I use those commands a lot when doing roadway projects. I am often adding 100+ heads at a time. while those heads may not be one zone, it would be much easier to erase a pipe segment here or there than to draw lateral line between 100+ heads.
Jeremiah Farmer Pending Moderation
Accepted Answer
03/19/2018 @ 3:58 pm
2
Votes
Undo
Michael,

We were actually just talking about this! Of adding an option both when placing and copying, to automatically add lateral pipe to the last head.
It's definitely on the list, I'll see what we can do.

--J
Dan Dieleman Pending Moderation
Accepted Answer
02/22/2019 @ 12:33 pm
0
Votes
Undo

That would be awesome! Also, the feature to indicate the best place to pipe lateral to on a zone, like someone else already mentioned. Excited to see what happens with that!

Chris Billete Pending Moderation
Accepted Answer
04/17/2019 @ 1:19 pm
0
Votes
Undo

Make this happen, this would save so much time!  The only think I see that would need a control is the flow zones or max flows.

  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.

Contact

  • Land F/X

Our software tailors AutoCAD to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.

Log in to landfx.com:

Username:

Password: