sales@landfx.com
+1 805-541-1003

Land F/X Community Forum

Naturalist
0
Votes
Undo

We have submitted the irrigation system design but there are some changes in the architecture and landscape . Now we need to update existing design. Do you have some power tips or webinars on this issue? I guess we could start with deleting and adding ,but I guess we could miss something and end up with problems... Thank you , Nemanja

Jake Lott Pending Moderation
Accepted Answer
See in context
04/23/2019 @ 7:59 am
0
Votes
Undo

Naturalist,

We have several tools that will help in adjusting and revising your irrigation design. Among these would be the Replace, Move piped equipment and Match Properties tools. I have responded to you via the Tech Support ticket you submitted. Once we determine the best course of action for you, I will make sure to post the resolution we came to. 

Regards,

Naturalist Pending Moderation
Accepted Answer
See in context
07/10/2019 @ 5:21 am
0
Votes
Undo

Hi Jake,

I have one more question. Turf area are reduced and I need to delete rotary heads and to downsize the whole station. Is it somehow possible to delete these heads and not to delete entire station, because around 30% of heads and pipes will remain? I am afraid to delete with simple deleting , but sometimes it seems it is inevitable. Off course I need to pipe them all together at the end and to verify laterals, size them and finally verify and size mainline...

Just to make it more illustrative I am sending snapshot .

 

BR

Nemanja

 

Attachments (1)
Naturalist Pending Moderation
Accepted Answer
See in context
07/10/2019 @ 6:31 am
0
Votes
Undo

Here is one more:

 

Within the same design i have deleted whole station No. 5 . Is there a quick waz to restart numbers from 5 to 15 within valve callouts ?

Jake Lott Pending Moderation
Accepted Answer
See in context
07/10/2019 @ 7:30 am
0
Votes
Undo

Nemanja,

Yes, we do have a few tools that will save you a bunch of time on these revisions. Your best bet for deleting parts or all of a station is with our Delete Station Tool. Following the steps within this article you will find a few different options to use, based on what you want to do.

If you want to keep a portion of the station, simply manually delete one section of pipe (separating things into now two “stations”), then run delete station on the given area.

To re-number your callouts, it is as easy as calling out a previously called out valve with a new starting number. The system will reorder things for you. We have a Power Tip that covers this here.

  • Page :
  • 1


There are no replies made for this post yet.
However, you are not allowed to reply to this post.

Contact

  • Land F/X

Our software tailors AutoCAD to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.

Log in to landfx.com:

Username:

Password: