The system auto shifts the heads symbol in from the insertion point so the symbol lands right within the corresponding coverage arc. This way you don't have overlapping symbols when sharing the same edge, placed on opposite sides of that edge.
Is there something you were hoping to achieve? Any examples you might be able to send over so we can see what you are after?
Sure, I normally try to make the plan as clear as possible. Usually 20 scale. When I get to areas that are tight I end up moving the heads to the outside of the areas, where the pipe is just inside the adjacent hardscape line. Image attached.
That is a great suggestion, Tom. I would also venture to say you might try and test out different symbol styles, as the square symbols are a bit bigger than the others, simply by the shape. Keep in mind that the system is offsetting exactly the width of the symbol.
I would also suggest simply placing the head just outside the edge since you know where it will be positioned from insertion point.
There are no replies made for this post yet. Be one of the first to reply to this post!
Please login to post a reply
You will need to be logged in to be able to post a reply. Login using the form on the right or register an account if you are new here. Register Here »