Thank you for the reply below for my support ticket..
am putting it here for the benefit of all others irrigation designers in case they faced similar situation..
Thank you for reaching out. We're looking in your project files. Jake also linked me to your Land F/X thread post.
I found that you are correct, the Bars for the "TURF ROTOR 5000" was wrong. It was roughly listing the PSI of the head instead of the Bars. If you click edit equipment on the turf rotor 5000, you can re-select 2.4 Bars, and it will adjust the pressure to that.
In your community post, you also stated that the turf rotor 5000 is not functioning properly when placing it. Could you describe that further to me?
I did edit the equipment and chose 2.4 bars in the design pressure window but still showing high bar.
5000 Rotor head series is functioning weird while placing as attached. it also giving small radius not like before.