Trying to use the circuiting tool to determine quantity of valves needed/ divide up drip areas. Running the tool causes autoCADD to freeze/ crash. I have nuked all xref's in an attempt to ensure that all files are clean. Then removed all xref's except the planting xref which is needed to calculate the flow rates. Still having the same issue.
Also, noticing that I'm getting outrageous flow rates such as 420.67 and if I try to divide the area into smaller sections it's still giving me the same flow rate or reducing it by 1/10th even though only showing about 1/5th of the area previously calculated. Running it multiple times sometimes gives me a different number for the same area i.e. instead of 420.67 I will get 19.87 or 11.33.
Any support on what is happening would be greatly appreciated.
Also, noticing that I'm getting outrageous flow rates such as 420.67 and if I try to divide the area into smaller sections it's still giving me the same flow rate or reducing it by 1/10th even though only showing about 1/5th of the area previously calculated. Running it multiple times sometimes gives me a different number for the same area i.e. instead of 420.67 I will get 19.87 or 11.33.
Any support on what is happening would be greatly appreciated.
- Page :
- 1
There are no replies made for this post yet.