Thursday, 22 May 2025
  1 Replies
  319 Visits
0
Votes
Undo
I notice at times the “Maximum Station Flow” on the Critical Analysis report will show a different value and not the maximum GPM value that shows on the Valve Schedule report. Just wondering if this is correct. If so, then how is the number generated, because I have also notice that this value doesn’t equal any of the GPM values on the Valve Schedule report. I have attached a picture showing an example.
Pat,

My best guess is that it is a looped mainline and the system is incorrectly logging the proportional GPM rather than the valve’s full flow. If you send in the file we can find out.

—J
  • Page :
  • 1
There are no replies made for this post yet.