Is it possible to add additional sub-categories in the detail graphics folder? I would like to create Masonry>Concrete Masonry Unit>Section/Elevation>(Block Type). Where block type could be Splitface, Slump, Smooth, ect.
. . . If I create the (block type) folders under the CMU section they show up. But it doesn't seem that I can go any deeper than that.
. . . If I create the (block type) folders under the CMU section they show up. But it doesn't seem that I can go any deeper than that.
Clay,
You can have up to 4 levels of hierarchy for blocks, as in:
/Detail_Graphics/Level_2/Level_3/Level_4
We are looking into allowing a fifth level, the soonest that would happen is middle of next year.
--J
You can have up to 4 levels of hierarchy for blocks, as in:
/Detail_Graphics/Level_2/Level_3/Level_4
We are looking into allowing a fifth level, the soonest that would happen is middle of next year.
--J
- Page :
- 1
There are no replies made for this post yet.