I placed a master valve in my irrigation plan but it was so huge symbol.. As shown in the attached pdf..
what can i do to place it in the normal size?
Thank you
Nibal
Hello all,
would like to share with you all how this worked with me and solved the problem with the wrong scale of the master valve in case it happened with any of you.
The way it worked with me that I started a new clean drawing and attached the needed xrefs and placed the master valve again and it came in the right scale..
The problem is most probably in the drawing itself.. because i tried in another project and it was fine..
Thanks again Jake
Nibal
Nibal,
Without seeing the drawing all I can guess is that your Master Valve block is set to the wrong units, and the system is putting the wrong scale factor to the block when inserting it at the proper size. Further, that block is now defined in the drawing as such, so even when deleting and placing again, it shows big. It sounds like you need to delete, purge, and fix the block before inserting it again.
If this doesn't work for you, please send in the proper files in a tech support ticket and we can make sure to get you the proper steps in fixing your plan.
Regards,
Hello all,
would like to share with you all how this worked with me and solved the problem with the wrong scale of the master valve in case it happened with any of you.
The way it worked with me that I started a new clean drawing and attached the needed xrefs and placed the master valve again and it came in the right scale..
The problem is most probably in the drawing itself.. because i tried in another project and it was fine..
Thanks again Jake
Nibal
- Page :
- 1
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.