I am having an interesting issue with a couple of zones on an irrigation plan I am working on. The circuiting tool shows 21.22 gpm but the label after sizing the pipe shows 32.1. I have repiped the the zone to make sure that I didn't double pipe something. Any thoughts on why the numbers are different for the same zone?
Any suggestions would be greatly appreciated.
Any suggestions would be greatly appreciated.
Brandon,
Have you tried clicking the "Recalc" button in the circuiting dialog box? It could be that or something a little more tricky. It sounds like you might have something else hooked to the valves somewhere in the drawing. Using the highlight tool, clicking on the valve might show you where that is. You can always send in your drawing and project data and we can take a look for you. We are awesome like that!
https://www.landfx.com/kb/item/125-how-to-submit-a-support-ticket.html
Have you tried clicking the "Recalc" button in the circuiting dialog box? It could be that or something a little more tricky. It sounds like you might have something else hooked to the valves somewhere in the drawing. Using the highlight tool, clicking on the valve might show you where that is. You can always send in your drawing and project data and we can take a look for you. We are awesome like that!
https://www.landfx.com/kb/item/125-how-to-submit-a-support-ticket.html
Or it could be that there are both Turf and Shrub heads in there, so the Circuit is showing a lower total than what is connected to the valve.
--J
--J
Figured out that the "special" sprays defaulted to a shrub spray body instead of the turf spray body. sorry for the headache, but thanks for the quick responses.
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.