Hi,
I'm having a similar issue to the post from Mid-January about High GPM calculated in drip zones. Except in my case I'm using dripline, not drip area. I originally replaced the dripline in the project with a different brand and spacing/gph. When attempting to size lateral line, it errors out and says I need greater than 3". So I deleted the dripline, and added new. Still errors out.
My calcs show that for this single zone in my project (drawn off the plan, until we figure out what's wrong), I should only have about 7.7 gpm. Definitely not 3" lateral material.
Can someone poke around? This drawing is a mess, too many people futzing around. Suspect that's part of the problem.
Thanks,
Julie
I'm having a similar issue to the post from Mid-January about High GPM calculated in drip zones. Except in my case I'm using dripline, not drip area. I originally replaced the dripline in the project with a different brand and spacing/gph. When attempting to size lateral line, it errors out and says I need greater than 3". So I deleted the dripline, and added new. Still errors out.
My calcs show that for this single zone in my project (drawn off the plan, until we figure out what's wrong), I should only have about 7.7 gpm. Definitely not 3" lateral material.
Can someone poke around? This drawing is a mess, too many people futzing around. Suspect that's part of the problem.
Thanks,
Julie
- Page :
- 1
There are no replies made for this post yet.