Incorrect irrigation legend counts
By Julie Riddle on Friday, 13 May 2016
Posted in Irrigation
Replies 1
Likes 0
Views 2.4K
Votes 0
We've had three projects in the last few days where the counts of a product in the legend were not true to the actual number of product drawn on the plans. In the attached project, you can see that the rotor total in the legend is 46, but if you count the actual plan symbols, there are 56. In the previous project, the pipe length was incorrect. We can't figure out what is causing this. Hoping someone can help or offer advice. Thanks.
It's because some of those were placed as Hunter I-20 rotors, instead of PGP's.
To locate the errant rotors, you can place one of each off to the side, and then use Highlight Station -- it will highlight all rotors that match, which you can use to track down the ones that are not highlighting. You can then use our Match Properties tool to reassociate them correctly.

--J
Jeremiah Farmer
·
7 years ago
·
0 Likes
·
1 Votes
·
1 Comments
·
Excellent, this solution worked great. I don't have the Match Properties tool available in my toolbar, oddly, but I was able to access it in the command ribbon as FX_MATCHPROP so it exists somewhere. Thank you much Jeremiah.
Julie Riddle
7 years ago
#21
View Full Post