Sorry if this question has been asked already (I tried searching), our office is new to Land F/X.
Our office convention is to have an area of subsurface drip be center fed by the valve and graphically show laterals branching off from the central lateral to either end of the drip area. I'm trying to do this in F/X but when I go to size the laterals the software chooses one run of lateral as the only pathway for the water. So if I check the flows in any of the other legs for that drip area the flow is 0.0 gpm. Is there a work around or can F/X only process a single leg for a drip area and will just ignore the other legs?
Thanks in advance for any help.
Our office convention is to have an area of subsurface drip be center fed by the valve and graphically show laterals branching off from the central lateral to either end of the drip area. I'm trying to do this in F/X but when I go to size the laterals the software chooses one run of lateral as the only pathway for the water. So if I check the flows in any of the other legs for that drip area the flow is 0.0 gpm. Is there a work around or can F/X only process a single leg for a drip area and will just ignore the other legs?
Thanks in advance for any help.
There are no replies made for this post yet.