Hello all,
First sorry if this question is not about the software..
and i need help from the experinced irrigation designers who are using the land/fx
I am working on an irrigation plan and i have an existed point of connection size 25 mm and i got 3 valves connected to this point of connection..
After i sized all the valves and the mainline i got two valves of three(207 l/m, 80 l/m) exceeded the available flow rate at the point of connection(76.62 l/m)..
And actually its the first time am facing this case.. any one please can help with the most proper solution?
thanks
Nibal
- Page :
- 1
There are no replies made for this post yet.