MOVE PIPED EQUIPMENT
By Nibal Ata on Monday, 03 April 2017
Posted in Irrigation
Replies 4
Likes 0
Views 2.1K
Votes 0
I noticed while using the move piped equipment that some of the fittings which connected the two bubblers pipes move only one pipe( as there are two fittings).. and the others move the two connceted pipes together(as there is one fitting)..

so what is the right to have two fittings or only one?

if only one, what am i doing wrong to have two?
thanks
Nibal,
All this means is that you have piped these areas a bit sloppy. There should only be one fitting per side, and if you use the Move Piped Equipment tool on a fitting, all pipes that are connected should go with it. If you do move pipes and there is a pipe that is left, that just means you somehow drew two pipes on top of one another, and you will need to clean those areas up.
Jake Lott
·
7 years ago
·
0 Likes
·
1 Votes
·
0 Comments
·
Thank you Jake,
I cleaned the area and draw the pipes again, but while drwaing the laterals , in some areas it didnt highlight the next head in green so it doubled the fitting..
and caused this sloppy piping..
Nibal Ata
·
7 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
Too zoomed out? That happens sometimes. Also, too zoomed in will cause this. The porridge should be just right.
Steve Cook
·
7 years ago
·
0 Likes
·
1 Votes
·
0 Comments
·
Thank you Seaweed..
Nibal Ata
·
7 years ago
·
0 Likes
·
0 Votes
·
0 Comments
·
View Full Post