I am trying to input 2 types of laterals. Lateral line pipe #1 has been identified as purple pipe in the remarks and now we need to add potable water pipe. I am trying to select lateral pipe #2, but the options of max flow vel., pressure var. factor, and fitting/safety factor are all grayed out. Same issue with Main line pipe #2 selection.
Ok thanks. Also, when I did change the pipe over to the pipe #2 it still finds 9' of the #1 pipe when I redo the schedule, even though there is nothing there...even did a filter to find it to no avail.
A little trick you could do to find this piece of pipe is to use our Work Areas tool to put around a section of your plan, using it almost like a magnifying glass. Run a schedule based on that work area and see if it shows up in the schedule that way. If it disappears from the schedule, move the work area around until it shows up. Once it shows up then make the work area smaller and regen the schedule. Repeat this until you see right where it is! If that doesn't work, let us know and we can go from there.
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.