It would be great if you could scale tree blocks based on a subset of data relating to canopy width when importing from CSV. Currently you can only select a tree block from your planting list.
Austin,
It's a good idea.
To have the tree sizes be variable, it would have to be just a Generic tree symbol, instead of being tied to a project tree.
I'll get this noted in the wishlist.
--J
It's a good idea.
To have the tree sizes be variable, it would have to be just a Generic tree symbol, instead of being tied to a project tree.
I'll get this noted in the wishlist.
--J
Great! A z-value for elevation is another idea if these generic blocks could be imported to revit using the 3d connection.
Austin,
Importing would need some data assigned to them through the plant manager or RefNote manager to use the 3D Connection.
Z-value wouldn't be needed since our 3D connection tool pops any imported families in Revit to floors and toposolids automatically. As long as the terrain is created in Revit correctly using Z values from your CSV, the families will host to it.
-Amanda
Importing would need some data assigned to them through the plant manager or RefNote manager to use the 3D Connection.
Z-value wouldn't be needed since our 3D connection tool pops any imported families in Revit to floors and toposolids automatically. As long as the terrain is created in Revit correctly using Z values from your CSV, the families will host to it.
-Amanda
- Page :
- 1
There are no replies made for this post yet.