The Radial dimensions appear to use the Second arrowhead preference.  So I'm guessing the only way you can pull this off, is to use an entirely separate dimstyle when dimensioning a radius?  Or is there a setting that lets you get away with it?  If you are able to do this all from a single dimstyle, we should be able to match it.  Just send over the drawing with this magical dimstyle, and I'll take a look at it.

--J

Oh, no I see!

Duh, sorry.

Actually, our dimstyle system can handle the four dimstyle types, I just didn't realize that the arrowhead can vary!

Anyway, long story short -- all the code for doing this is supposedly in place.  If it is not working for you, then still send over the magical dimstyle.  :P

--J