Dear Land F/X team,
I have corrupted valve callout placed in a new project.
Need help please to fix it.
Am not sure if it is a bug or something else.
Best Regards
Nibal
I have corrupted valve callout placed in a new project.
Need help please to fix it.
Am not sure if it is a bug or something else.
Best Regards
Nibal
Nibal,
From that screenshot, it appears the valve callout attributes are somehow scaled much larger than the callout.
I can't tell from the screenshot if the text is the correct size, or the valve callout.
You can try using ATTSYNC, to see it that solves it.
If the text is the correct size and it's the callout that is too small, that is most likely a unit issue. You could confirm the units are set correctly, purge the callout of of the drawing, and try it again.
But beyond that, and without any further information, we would need the drawing file to troubleshoot it further.
--J
From that screenshot, it appears the valve callout attributes are somehow scaled much larger than the callout.
I can't tell from the screenshot if the text is the correct size, or the valve callout.
You can try using ATTSYNC, to see it that solves it.
If the text is the correct size and it's the callout that is too small, that is most likely a unit issue. You could confirm the units are set correctly, purge the callout of of the drawing, and try it again.
But beyond that, and without any further information, we would need the drawing file to troubleshoot it further.
--J
- Page :
- 1
There are no replies made for this post yet.