Nibal,
You should be able to take advantage of the auto-numbering feature as you use the valve callout tool, which should eliminate the need to keep typing a valve number. You should then be able to simply press the Enter key to accept that number. Two clicks for the placing of each callout, then click the next valve and press Enter again.

Repeating this I was able to label 30 valves in under 5 min. Is there something I am missing?

Jake,

Thank you for the prompt reply:)

Please is there any power tip for using the auto-numbering feature??


Nibal

There sure is! Take a look at the link below on placing Valve Callouts.

Power Tip: Valve Callouts

What if we get rid of a valve? Is there a way to renumber them all automatically? I just deleted valve number three of 40+ valves.

Simply start with the lowest numbered valve. If, for instance, you removed valve 5, you would click Valve Callout and select valve 6, then change its number to 5, and the system will ask whether you wish to renumber the remaining valves.