Hello,
I'm using Match Properties to change from Hunter turf strip sprays to shrub strip sprays but it's not maintaining the radius and defaulting to the largest radius. Any ideas on how to get around this?
Jon
I'm using Match Properties to change from Hunter turf strip sprays to shrub strip sprays but it's not maintaining the radius and defaulting to the largest radius. Any ideas on how to get around this?
Jon
Jon,
This is currently not supported with the Match Properties tool.
It is, however, possible to clean up with Move Piped Equipment, albeit one head at a time:
- Move Piped Equipment, select a head,
- use A/S/D to adjust radius as desired,
- Right click to return head to original position with reduced radius.
I also added this to our wishlist for Match Properties.
--J
This is currently not supported with the Match Properties tool.
It is, however, possible to clean up with Move Piped Equipment, albeit one head at a time:
- Move Piped Equipment, select a head,
- use A/S/D to adjust radius as desired,
- Right click to return head to original position with reduced radius.
I also added this to our wishlist for Match Properties.
--J
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.