Hi All,
I've discovered that when you use multiple transition point symbols in a single drip zone, you have to first Highlight Zone before sizing, as the symbols seem to multiply the actual flow. Once you highlight the zone, the pipe will size normally. Is this a bug or a known thing?
Thanks!
I've discovered that when you use multiple transition point symbols in a single drip zone, you have to first Highlight Zone before sizing, as the symbols seem to multiply the actual flow. Once you highlight the zone, the pipe will size normally. Is this a bug or a known thing?
Thanks!
Highlight, or better yet, run Verify Laterals.
It needs to check each transition point against every single drip area in the drawing to see which one it is inside of.
As Verify Laterals should already be run before sizing pipes, we put it there.
—J
It needs to check each transition point against every single drip area in the drawing to see which one it is inside of.
As Verify Laterals should already be run before sizing pipes, we put it there.
—J
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD®, Revit®, SketchUp®, and Rhino® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.