The Rainbird R-VANs allow you to click and drop, to create a full radius, whereas the HE-VANs do not. If I try to adjust arc to 360 in Land FX it goes all around the circle and then shows radius as a line and does not have correct flow.
THis is also happening with me..
and most of the time when you check the flow rate after placing a 360 HE-VAN head(it shows a line instead of a full circle), you will find that the flow rate is either 0 or very little value which is incorrect..
Hope somone help to fix this..
Thanks
Nibal
and most of the time when you check the flow rate after placing a 360 HE-VAN head(it shows a line instead of a full circle), you will find that the flow rate is either 0 or very little value which is incorrect..
Hope somone help to fix this..
Thanks
Nibal
This was kinda known from before, I just try to get the spray radius as close to 360 as much as possible and adjust the block location so that the snap center for the head radius is on the insertion point. flows seem fine.
Landscape Designer
Belt Collins Hawaii
808-521-5361
Belt Collins Hawaii
808-521-5361
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.