Really like the information provided early in a project through the schematic irrigation tools. In looking through the documentation it does not appear there is any magic or special precautions related to editing a placed irrigation zone once connected to a valve with a segment of lateral pipe. I know deleting piped equipment without using the specific "delete Piped Equipment" tools when working with emitters is a no no. What is protocol when a schematic area that is connected to a valve needs to be altered or deleted?
On a related note, is there any documentation regarding best practices from transitioning from schematic irrigation to more detailed irrigation layout (emitter and lateral system components). Should schematic layers be deleted or just frozen? Can schematic drip zones be converted into drip areas? Can lateral segments used to connect a valve to a schematic zone be extended to emitters as the design advances?
Sorry if these are dumb questions, just a bit gun-shy of practices that may result in erroneous output later in the design process.
Thank you,
On a related note, is there any documentation regarding best practices from transitioning from schematic irrigation to more detailed irrigation layout (emitter and lateral system components). Should schematic layers be deleted or just frozen? Can schematic drip zones be converted into drip areas? Can lateral segments used to connect a valve to a schematic zone be extended to emitters as the design advances?
Sorry if these are dumb questions, just a bit gun-shy of practices that may result in erroneous output later in the design process.
Thank you,
There are no replies made for this post yet.