I have a large riparian restoration planting and it fits at 1:30 scale on 11x17.
I would like to break it up into smaller sections and show them at 1:10 scale, with each section on 11x17.
Is the Work Area a good solution for this? I haven't used them yet, but it seems like it's a good strategy.
David,
Work Areas are not necessary to accomplish what you describe, changing a 1:30 plan to three 1:10 plans. What work areas will primarily offer, is the ability to create a separate schedule for each sheet, or even a single schedule with quantity columns for each. Further, if any of the sheets was to have a differing scale or UCS, work areas can also assist with that. Check them out more in this Power Tip.
--J
Thank you.
So, to do it without Work Areas, is it just a matter of creating a new DWG, rescaling it and adjusting the viewport to feature the desired section of the drawing?
- Page :
- 1
Contact
- Land F/X
Our software tailors AutoCAD® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.