I made the mistake of editing a planting XREF from another drawing (edit XREF in place). After saving the changes, all the tree and shrub symbols became tiny-- I think 1/12 of the size they should be.
The planting drawing and the drawing it was XREF'd into are both decimal feet.
Groundcover hatches were not effected. When I place new trees and shrubs, they come in at the correct size.
Any idea how I can get the symbols back to the correct size without re-placing them all?
The planting drawing and the drawing it was XREF'd into are both decimal feet.
Groundcover hatches were not effected. When I place new trees and shrubs, they come in at the correct size.
Any idea how I can get the symbols back to the correct size without re-placing them all?
- Page :
- 1
There are no replies made for this post yet.