I'm getting a flow rate error message when trying to size the mainline. It indicates my flow rate is 200 GPM and asking if I'd like to edit the pipe data. My actual flow is 18.2 GPM in my Source Data so this is a head scratcher where this error message is coming from but it's preventing me from sizing the mainline.
Jon
Jon
Jon,
You can use Edit Equipment on segments of pipe, and check the flow of each until you trace it back to the source. It could be something like an invisible drip area hatch, or an error with calculating the flow for an adjustable head. You can also use Highlight Station on each valve to check its flow, and to see if any large invisible hatches are highlighted.
—J
You can use Edit Equipment on segments of pipe, and check the flow of each until you trace it back to the source. It could be something like an invisible drip area hatch, or an error with calculating the flow for an adjustable head. You can also use Highlight Station on each valve to check its flow, and to see if any large invisible hatches are highlighted.
—J
And if none of those work, you can remove pieces of the mainline to isolate the element causing the issue.
- Page :
- 1
There are no replies made for this post yet.
Contact
- Land F/X
Our software tailors AutoCAD®, Revit®, and SketchUp® to the needs of landscape architects, irrigation designers, and other professionals. We automate your most tedious tasks and ensure accuracy, giving you more time to design.