Is there a way to make the drip tree rings/spirals into a regular feature within the drip category where we can toggle to different volumes/sizes simialr to how we do it with overhead irrigation emitters. Over the last 12 months we have been experimenting with drip tree spirals on several of our design/build projects testing out lengths, emitter spacing, tree size, length of tubing etc. We have begun to implement their use on our design side of things. We have found that a one size fits all to tree rings does not necessarily work and the the volume to each tree/shrub should/will vary. We followed creating a drip tree spiral from the power tip video for drip tubing at .9gph at a 12" inch spacing for a 48" box tree. Is there a way to create a 'family' of drip tree spirals that go for tree sizes from 15 gallon to 144" box, spacing from 6" to 18" and from an emitter flow rate of .4 to .9 that I can select the emitter flow rate, then spacing and then toggle through to the appropriate tree ring size? The only other solution I can think of would be to create custom tree spiral blocks based on every variable which would result in about 99 different configurations of drip tree spirals. If it can be simplified so the drip tree ring/spiral is not a custom block but a regular feature in the drip category that I can select parameters and from there I have 11 configurations to tab through and drop into our plans. Hopeully this makes sense.
Thanks for your help in advance.